Scan buttons not functioning after Telnet / Emulator closes

Version 2

    Problem/Issue:

    Scan buttons are not functioning after Telnet / Emulator closes.

     

    Cause:

    A parameter needs to be set to allow this work when Telnet closes.

     

    Solution:

    Set scanner to function after close through the emulation section on the product configuration.

     

    You must set up a password for Session Monitor in the emulation parameters.

     

    • Open Telnet Config Utility
      Main.png
    • Open Emulation Parameters
      EmulationParameters_button.png
    • Navigate to Scanner>Common>Enable Scanner on Exit
      EnableScannerOnExit.PNG
    • Click Save to Save your settings 
    • EmulationParameters_save.png
      • Click 'Application & Config' OR 'Config Only' to send down the settings to the device. 
        application_config_and_config_only.png
    • Restart Telnet on the device.