RS507 Scanner not beeping after scans

Version 1

    Problem/Issue:
    There is no beep after I scan a barcode when scanning using the RS507. I am scanning my barcodes but when I do I do not get a beep after each scan.

    Cause:
    In the case of the RS507, when Telnet is handling the beeps, it may be difficult for a user to hear the beeps. This is because Telnet, which is running on the device, not the scanner, is controlling the beeps and using the sound hardware on the device. If you are 10 or 20 ft. away from the device, then you are probably not going to hear it beep, because it is coming from the device.

    Resolution:

    If you set the option under the emulation paramaters " Use Integrated Scan Beep" to YES then the device in this case the RS507 will handle the beeps not Telnet.

     

    Additional Information:
    Applicable Product Version(s): TelnetCE 7.0.x, 7.1.x, 7.2.x
    Applicable Device(s): RS507
    Notes: This may also be the case with other external scanners and is an option you should try if you are experiencing the same symptoms.

     

    rs507.jpg