Rollup: How to rollup ip address only

Version 1

    Environment

    LDMS 9.0, LDMS 9.5

     

    Question

    How do I configure my rollup core to only rollup IP Address changes? This can be useful if you are using your rollup core to remote control devices in an environment where client ip addresses change a lot. The benefit with IP only rollup is that rollup tasks will complete much quicker than full rollups.

     

    Answer

    Enable the following registry key, and follow these steps to configure your rollup core to only rollup IP Addresses.

     

    HKLM\Software\Wow6432Node\LANDesk\ManagementSuite\Core\Enable IP Only Rollup

     

    Set the DWORD equal to 1.

    rollupipreg.JPG

     

    Schedule a Task to Synchronize IP Address information only in the rollup utility.

    iponlysched.JPG

     

    Login to the console to run your task. You should see your IP only rollup task under "All Tasks" in the scheduled tasks window.

     

    sched.JPG