CETerm: Getting to my configuration dialogs from full screen mode

Version 1

    Verified Product Versions

    CETerm 5.7

    Applies to: CETerm, CE3270, CE5250, CEVT220



    When configured in full screen mode, the whole device display area is occupied by the terminal. You not have access to the Windows CE / Pocket PC Start button or the application menu and toolbars as these are all hidden.

    This article describes how you can get back to your configuration dialogs



    This article applies only to CETerm, CE3270, CE5250 or CEVT220 version 4.1 or higher.

    You can get back to your configuration dialogs form such a configuration via a special Context Menu. If you tap and hold the stylus towards the top left edge of the display screen, you will see a context menu appear. If the Start bar is visible, then tap an hold on the top left edge right below the Start bar. Your options will be to “Connect”, “Configure” or “Program Exit”.

    Choosing "Configure" will bring up the configuration dialog. If you have configured an access control password, you will be required to enter this, prior to getting access to the configuration dialogs.

    The screenshot below shows the top left area, which will invoke the special context menu. This is circled in red.

    Additional Information