Properly Launching HEAT Installer

Version 1


    Properly Launching HEAT Installer


    In order to properly launch the HEAT installer and ensure your best chances for success, it is recommended to perform the following:

    (Steps 2 and 3 only apply to Windows Operating Systems Vista and Above, and Server 2000 and Above.

    1. Copy the executable to the desktop of the machine that will host the HEAT Modules
    2. Right click on the executable after copying, and select Properties.  Verify there is not an "Unblock" button at the bottom of the general tab.  If it exists, press the button, and hit OK and Close.  Go back to properties to verify that Unblock stuck, and the button is not there.
    3. Finally, launch the executable with elevated privileges, by right clicking, and selecting "Run as administrator" from the menu.