Drive and Port Mappings are refreshed when session reconnect occurs

Version 3
Created by dennis.vandam on Apr 13, 2018 12:05 AM. Last modified by dennis.vandam on May 4, 2018 12:24 AM.

    Problem

    Consider the following scenario:

    • Wait for task to finish is not configured for a Drive Mapping
    • Action for the drive mapping is set to "Map drive"
    • A session returns from a disconnected to a connected state

    In this scenario, the User Event Log will show a message "Mapping %driveLetter% to %UNCPath% (asynchronously).

    The end-user will not be affected because the drives are not unmapped, the mapping will therefore fail.

     

    Solution

    This issue is resolved in Ivanti Workspace Control 10.2.800.0.