2 Replies Latest reply on May 7, 2008 1:44 PM by JDarrah

    Image fails to copy - Exit code -1917386763

    Apprentice

      Here's the full log:

       

      "Machine","CbaStatus","ExitCode","Duration","Begin","End","Command"

      "<mac address>","OK",0,0:00:00,4/23/2008 1:58:04 PM,4/23/2008 1:58:04 PM,"WINPE, TIMEOUT=1800"

      "<mac address>","OK",230227968,0:00:03,4/23/2008 1:58:04 PM,4/23/2008 1:58:07 PM,"drvmap.exe <user> <encrypted pw> I: <qt/>
      <network location><qt/>, STATUS FACILITY=3513"

      "<mac address>","OK",230227968,0:00:01,4/23/2008 1:58:07 PM,4/23/2008 1:58:08 PM,"drvmap.exe <user> <encrypted pw> H: <qt/>
      <network location><qt/>, STATUS FACILITY=3513"

      "<mac address>","OK",0,0:00:01,4/23/2008 1:58:08 PM,4/23/2008 1:58:09 PM,"diskpart /s X:\LDClient\wipeDisk0.txt"

      "<mac address>","OK",0,0:00:05,4/23/2008 1:58:09 PM,4/23/2008 1:58:14 PM,"cmd /c format /Y /FS:NTFS /Q /V:C-DRIVE c:"

      "<mac address>","ERR_Fail",-1917386763,0:00:00,4/23/2008 1:58:14 PM,4/23/2008 1:58:14 PM,"RunBatch -1 h:\osd\imaging imagew.exe /RN /O i:\Prod\CoreImag.IMG, STATUS FACILITY=3510, SYNC"

      ; "Job Complete","0 Done","1 Failed","0 Off","0 Unknown"

       

       

      Other info:

       

       

      Using WinPE.  Imaging works on other machines, just not this one (it's a Latutude D600, other D600's image OK). The machine flashes a window when the last line, "RunBatch..." is run. Machine is responsive after that but fails to image. I opened a console from that machine and H: and I: were properly mapped. I ran the line that failed manually and it flashes a window then closes it, no status text in the console window. The BIOS sees the 20GB hard drive.

       

       

      Thanks in advance!

       

       

      Jason