This content has been marked as final.
Show 2 replies
-
1. Re: Hangs at LANDesk screen when imaging using symantec imaging tool
dblansky Mar 5, 2014 7:32 PM (in response to lthompson)I ran into something similar on some newer HP devices. It turned out that my ghost application was 32 bit, but ldprovision was running in 64 bit mode.
I had to go into the bios setup & disable EFI Boot sources...
on the boot menu in the HP bios, select efi boot sources, tap F5 to disable & F10 to save.
once the efi boot sources were disabled, the provisioning task ran in 32 bit mode & was able to kick off the ghost32 properly.
-
2. Re: Hangs at LANDesk screen when imaging using symantec imaging tool
Alex.Richardson Mar 5, 2014 7:53 PM (in response to lthompson)What dblansky said could be the issue but I have also seen older versions of Ghost not run corretly in the newer version of WinPE.
What version and SP of LDMS are you on and what version of ghost?