Does the maptopreferredhandler.exe not work? If the preferred server is setup correctly this command should find it for the IP range assigned.
OK, have to ask. Why do you want to change it?
If you specifically want to use a particular server you could try setting up actions that manually map to the required server rather than using the inbuilt ones that assume the use of the preferred server.
If the issue is that the auto-selection is incorrect, have you looked at the IP address range setting in the preferred server definitions so that machines on a particular subnet would use that one over all others?
MarXtar Ltd/MarXtar Corporation
LANDESK One Development Partner
The One-Stop Shop for LANDESK Enhancements
Thanks for your suggestions.
It's mostly to correct human failure.
When you run the first tests and notice, that maybe an IP range is missing, but you can't reboot to WinPE (different time zones, faulty PXE..), then I would like to manually assign a PS for the image deployment.