2 Replies Latest reply on Oct 26, 2016 2:47 PM by Peter Massa

    Trying to get a custom patch definition to work

    GJHorn Specialist

      I created a custom patch definition to handle the Safari 10 El Capitan update. I have all the detection logic configured. I'm using the bash command -- softwareupdate --install "Safari10.0elcapitan-10.0" -- in the patch installation & removal -> patch install commands section. The patch is detected and repaired but Safari 10 is not installed. The patch says "everything worked" after the patch definition is installed. I'm not sure why the commands are not running properly.

       

      Does anyone have a clue why?

       

      the full patch install commands are:

       

      #!/bin/bash

      softwareupdate --install "Safari10.0elcapitan-10.0"

      exit 0

       

      I tried without the quotes as well with same result.