I'm still trying to learn how this tool works as there doesn't appear to be any video step-by-step tutorials on how to use the application. I've installed it, went through the steps to configure endpoints for discovery and ran the Discover Asset session. The IP addresses turn up but not the NetBios names. It's going to be hard to to identify who uses the unit without the name however.
On a scan of a different network, the NetBios names are resolved but I suspect it's because the Windows Firewall is turned off.
Hi James. For the discovery process to function properly and resolve NetBIOS names, there are certain ports that need to be open from EMSS server towards target endpoints. They are as shown below. So you were right it is likely a firewall issue.